Aputure INFINIBAR PB6 & PB12 Pixel Bars — Dry Hire

The Aputure INFINIBAR is an RGBWW LED pixel bar built for set dressing, practicals and effects where a conventional fixture would be too big or too static. We dry hire both sizes: the PB6 at 60cm and the PB12 at 120cm. They share the same colour engine and control, so the two sizes mix freely on the same job.

Each bar runs as a single source or as an addressable strip — 48 pixels on the PB6, 96 on the PB12 — which is what makes them useful for chases, sweeps, pulsing practicals and in-camera effects rather than just another soft source. Colour runs from 2,000K to 10,000K with CRI 96+ and TLCI 98+, so they hold up against broadcast cameras rather than only looking good by eye.

They are light, magnetic-mountable on the INFINIBAR rail and clamp system, and run on internal batteries for roughly 100 minutes (PB6) or 80 minutes (PB12) at full output, which means they can go where there is no power — inside a set build, behind a desk, under a table, rigged to a vehicle.

Key Specs

  • PB6: 60.4cm, 48 pixels, 18W draw, approx. 100 min battery at full output

  • PB12: 120.4cm, 96 pixels, 36.5W draw, approx. 80 min battery at full output

  • RGBWW in single-pixel mode, RGB in multi-pixel mode

  • 2,000K – 10,000K, CRI 96+ / TLCI 98+

  • Max illuminance 1,048 lux at 0.5m (PB6) and 1,650 lux at 0.5m (PB12) at 6,500K

  • Control via Sidus Link app, DMX/RDM and LumenRadio CRMX

  • INFINIBAR rail and clamp mounting; mains via 100–240V adapter or internal battery

  • IP20 — indoor use, keep dry

Best for

  • Set dressing and practical sources in studio builds and webcast sets

  • Music, promo and branded content needing colour, chases and movement in shot

  • Interview and podcast backgrounds that need a lift of colour without a lighting rig

  • Virtual production and LED volume support lighting

  • Tight and awkward positions where battery power and a slim body are the only option

Collection and delivery

Dry hire collection is from Coldharbour Lane, Harpenden, Hertfordshire AL5 4UN — minutes from the M1 and close to Luton, St Albans, Watford and north London. We deliver UK-wide, and bars can be supplied crewed if you would rather we rig and programme them.

Bars are supplied with mains adapters as standard. Rails, clamps, additional mounting and DMX or CRMX control are available on request — tell us how you plan to rig them and we will put the right kit in the case.

Related equipment

READY TO HIRE THIS EQUIPMENT?

Get in touch with our team to check availability, discuss technical requirements, or book your dry hire.

Get In Touch